Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Maestro Slice A and B confusion
I have not seen you control function swap But a short push on A knob (AF) should mute slice B ( solo) and a long push on A knob should mute slice A AL, K0VM1 -
Re: Maestro problem with straight key
for stright key, Use a 1/8 TRS onnector then in the Maestro MENU>Phone/CW menu, set Iambic Disabled and Swap(DASH/DOT) enabled. This should allow you to use a straight key on the tip of the connec…1 -
Re: Splatter TX on 6500
The spacing of the spikes (~ 60/120hz) would indicate that there may be a power supply regulation problem. Is the power supply dropping out of regulation under load ? AL, K0VM1 -
Re: Splatter TX on 6500
Keith, The spectrum shown during transmit is infact the leakage path trough the TR switching.from the transmit feed line into the still active receiver. It is a fairly good representation of RF going…1 -
Re: Splatter TX on 6500
I don't know for a fact but suspect it is open unless an alternate RX antenna is selected.. AL, K0VM1
